Filter
Top Products
Ch 2: Installation and Use of Devices
18 Hitachi PC VisionBase8450H/R Server
29 Load Fail Error Blinking • Loading the tape failed.
• A load command or change partition command to read
the system area of the tape failed. Use a new cartridge.
30 Load Tape Information — This is displayed when the tape load button is pressed.
31 Loading Status — • The cartridge is being moved from the magazine to the
drive.
• The cartridge is being loaded by the drive.
32 Locate Status — The drive is moving the tape to the point specified by the
host.
33 Mag Check Status — The autoloader is checking the magazine slot.
34 Mag Eject Status — The autoloader is ejecting the magazine.
35 Mag Loaded Status — The magazine has been loaded into the autoloader and
checked.
36 Media Removal
Prevented
Error On An attempt was made to eject a cartridge when cartridge
ejection is inhibited. Use the SCSI command or reset to
cancel the ejection inhibition.
37 New FW!!! Status — Upgrading of firmware completed.
38 No EODmark Error Blinking Data in the tape contains no EOD (A possible cause is that
a write operation was performed when power supply was
abnormal).
39 Partition Status — The drive is switching a two-partition tape to a different
partition.
40 Partition 1 too
large
Error On Formatting failed because the size for one partition is too
large. Decrease the partition size or use a longer tape.
41 Read Status — The drive is reading data from tape.
42 Read Fail Error Blinking Reading data failed. Reset the position of the data, and
retry.
43 Ready xxm Status — A cartridge has been loaded into the drive, and the tape
motion command has become executable (“xxm” indicates
the length of the tape loaded. For a write-protected
cartridge, “Read Only” is displayed).
44 Rewind Status — The drive is rewinding the tape to the beginning of the
partition.
45 SCSI Error Error On An SCSI command error has been detected. Check the
SCSSI cable for connection, and retry.
46 SCSI ID: x Information — Indicates the SCSI ID of the autoloader. This is displayed for
two seconds succeeding to the product ID when power is
turned on.
47 Search << Status — The drive is searching for a record, file mark, set mark, or
BOD to the beginning of the tape.
48 Search >> Status — The drive is searching for a record, file mark, set mark, or
EOD to the end of the tape.
49 Select Tape Information — This is displayed when the select button is pressed.
No. Message Type Operator-
alert lamp
Meaning