Filter
Top Products
Ch 3: Installing Optional Devices
Hitachi PC VisionBase8450H/R Server 73
1. Set a SCSI ID for the internal DAT changer.
Use the short bar to set the SCSI ID into the range of 0 to 6. Use a pair of tweezers for inserting and removing
the short bar.
The following table shows the correspondence between the SCSI IDs and the settings on the short bar. The short
bar is factory-set at 3.
NOTE: You can use the internal DAT changer without setting a terminating resistor, because a terminating
resistor has already been installed in the internal SCSI cable (for removable devices).
Store the removed short bars properly.
Be sure to set SCSI IDs so that there is no duplication within the group of SCSI devices connected
with the same internal SCSI cable.
SCSI ID Setting on the short bar
0
1
2
3
4
5
6