Ch 2: System Environment Setting
Hitachi VisionBase 8880R Server 45
4.
The [Card Configuration] dialog box is displayed. Select and change the resource as necessary.
5.
Exit the ICU, and turn off the system equipment.
6.
Change the settings on the extended board, and install that board onto the system equipment.
Removing an Extended Board
Before removing an extended board, you need to make ICU settings.
NOTE:
When you need to install an extended board in or remove it from the system equipment, call the
maintenance personnel.
1.
Start the ICU.
2.
In the [ISA Configuration Utility] window, select the board to be deleted, and choose the [Remove] button.
3.
A confirmation message is displayed. If you are sure that the board should be deleted, choose [OK].
4.
The [ISA Configuration Utility] window is displayed.
Check that the selected extended board has been deleted.
5.
Exit the ICU.
6.
Turn off the system equipment, and remove the extended board from the system equipment.
Built-in devices must be added or exchanged by maintenance personnel only. Be sure to avoid
removing the cover and installing/removing built-in devices. Otherwise, operation of the equipment
shall not be guaranteed.
Card Configuration
OK CancelSettings... Help
Card Name: Communication board
Configuration: Current Setting:
Communication board
I/O Address
DMA Channel Selection
Interrupt
0110h - 011Fh
Channel 5
IRQ10
Communication board
Motherboard System Devices
PCI Card: VGA Controller
PCI Card: SCSI Controller
PCI Card: Unknown Card
PCI Card: IDE Controller
ISA Configuration Utility
File Configure View Advanced Help
Card Configured In System:
Add Remove Modify View
