Filter
Top Products
Ch 1: Hardware
4 Hitachi VisionBase 8880R Server
Powering-On the System
Before turning on the system confirm that the main power LED (green), located on the front panel, is illuminated.
If so, you may press the Main Power Switch to boot the system. If the LED is not illuminated you will need to
manually access the individual power supplies and turn them on in order starting with Power Supply #1, located on
the far left. See the figures and directions below to assist you in accessing and turning on the power supplies.
NOTE:
Ensure direct power switch is in the “OFF” or normal position.
Figure 1 Accessing the Power Supplies (1)
Figure 2 Accessing the Power Supplies (2)
1.
Remove the Power Supply cover by opening the HDD bay door using the key, and then unscrewing and
removing the 2 screws located at the bottom of the HDD bay on the metal tabs. See Figure 1 Accessing the
Power Supplies (1).
2.
Open the Power Supply door by pulling it forward, it folds down to open exposing the power supplies.
HDDs
Power Supply Cove
r
HDD Bay Door
Remove these 2 screws
located on metal tabs
Power Supply door
folds down
Power Supplies