Filter
Top Products
2 - 2
RS-232
The RS-232 Interface barcode is used when connecting to the serial port of a
PC or terminal. The following RS-232 Interface barcode also programs a car-
riage return (CR) and a line feed (LF) suffix, baud rate, and data format as indi-
cated below. It also changes the trigger mode to manual.
Wand Emulation Plug & Play
In Wand Emulation mode, the image scanner decodes the barcode then sends
data in the same format as a scanner image scanner. The Code 39 Format
converts all symbologies to Code 39.
The Same Code Format transmits UPC, EAN, Code 128 and Interleaved 2 of 5
without any changes, but converts all other symbologies to Code 39.
The
Wand Emulation Plug & Play Code 39 Format
barcode below sets the
terminal ID to 61. The
Wand Emulation Plug & Play Same Code Format
bar-
code sets the terminal ID to 64. These Plug & Play barcodes also set the Trans-
mission Rate to 25 inches per second, Output Polarity to black high, and Idle
State to high. (If you want to change the terminal ID
only
, without changing any
other image scanner settings, please refer to Programming the Interface -
Terminal ID Method on page 2-6.)
Option Setting
Baud Rate 115200 bps
Data Format 8 data bits, no parity bit, 1 stop bit
RS-232 Interface
Wand Emulation
Plug & Play
Same Code
Wand Emulation
Plug & Play
(Code 39 Format)