Filter
Top Products
2 - 21
2020 Host Escape Commands
Wand Emulation
Wand Emulation Connection
The Wand Emulation Connection barcodes should be used if you want to
change the terminal ID
only
, without changing any other image scanner set-
tings. We recommend using Wand Emulation Plug & Play barcodes to program
your image scanner to emulate a wand reader. The Wand Emulation Plug &
Play barcodes change other parameters, in addition to changing the terminal ID.
Please refer to Wand Emulation Plug & Play on page 2-2 for further information.
In Wand Emulation mode, the image scanner decodes the barcode then sends
data in the same format as a wand scanner. The Code 39 Format converts all
symbologies to Code 39.
The Same Code Format transmits UPC, EAN, Code 128 and Interleaved 2 of 5
without any changes, but converts all other symbologies to Code 39. 2D sym-
bologies are converted to Code 128.
Command Action
<ESC> a Double beeps to indicate a successful menu change was
made.
<ESC> b Triple beeps to indicate a menu change was unsuccessful.
<ESC> 1 The green LED illuminates for 135 milliseconds followed by a
pause.
<ESC> 2 The green LED illuminates for 2 seconds followed by a
pause.
<ESC> 3 The green LED illuminates for 5 seconds followed by a
pause.
<ESC> 4 Emits a beep at a low pitch.
<ESC> 5 Emits a beep at a medium pitch.
<ESC> 6 Emits a beep at a high pitch.
<ESC> 7 Beeps to indicate a successful decode and communication to
host.
<ESC> 8 Triple beeps to indicate a decode/communication to host was
unsuccessful.