Filter
Top Products
3 - 20
If you select Use Authentication, you will also be asked to enter a passkey for
the Mobility Systems device. The PIN entered for the Mobility Systems device
must match the one configured on the image scanner. Once you select the
4820i device in Step 13 (page page 3-18), the following screen appears.
1. In the Bluetooth Passkey box, enter the image scanner’s PIN code. The
same Bluetooth passkey (PIN code) is required for each device.
2. Tap Reply.
Starting ScanWedge
Once the image scanner is linked to the Mobility Systems device, you need to
configure ScanWedge for the correct COM port and then start ScanWedge. For
additional information, refer to the Honeywell Powertools User’s Guide, which
can be downloaded from www.honeywell.com/aidc.
Out-of-Range Alarm
Duration
If your image scanner is out range of the base, an alarm sounds from both your
base and image scanner. To activate the alarm options for the image scanner
or the base and to set the alarm duration, scan the appropriate barcode below