Filter
Top Products
4 - 8
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free”
modes. If the image scanner’s trigger is pulled when using a hands free mode,
the image scanner changes to manual trigger mode. You can set the time the
image scanner should remain in manual trigger mode by setting the Hands Free
Time-Out. Once the time-out value is reached, (if there have been no further
trigger pulls) the image scanner reverts to the original hands free mode.
Scan the
Hands Free Time-Out
barcode, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and
Save
.
Default = 5,000
ms.
Reread Delay
This sets the time period before the image scanner can read the
same
barcode
a second time. Setting a reread delay protects against accidental rereads of
the same barcode. Longer delays are effective in minimizing accidental
rereads. Use shorter delays in applications where repetitive barcode scanning
is required.
Default = Medium.
Reread Delay only works when in Presentation Mode (see page 4-6).
Hands Free Time-Out
Short (500 ms)
* Medium (750 ms)
Long (1000 ms)
Extra Long (2000 ms)Extra Long (2000 ms)