Filter
Top Products
56
Security Seal Installation
Note: The certification of the weighing mechanism of the scale version of this scanner is subject to federal,
state and local Weights and Measures statutes and regulations and can only be performed by
authorized government agencies and/or their duly registered agents. Each time the scale or weighing
mechanism is calibrated, it should be properly sealed with a paper seal or a wire seal prior to being
placed into service in commerce.
It is the responsibility of the owner of the scale to confirm compliance with the relevant Weights and
Measures statutes and regulations applicable in your area by checking with the appropriate government
agency before placing a newly calibrated unit into service or removing any official seals.
Type of seal to be used will depend on the guidelines specified by the local Weights and Measures
authorities.
The security seal must only be installed if there were
no
Pressure Sensitive Security Seal
errors during the scale calibration verification tests.
1. Temporarily remove the platter and place it in a safe location.
2. Reinstall the calibration switch/button cover.
3. Apply the calibration security seal over the switch cover.
4. Reinstall the platter.
Figure 61. Calibration Switch/Button
Cover
Figure 62. Calibration Switch/Button
Security Seal Placement
Figure 63. Platter Installation