Filter
Top Products
57
Wire Security Seal (Seal Conversion Kit 46-00239)
1. Temporarily remove the platter and place it in a safe location.
2. Install the calibration switch/button cover.
3. Secure the cover in place with the flat head Phillips screw provided.
4. Thread the wire through the hole in the tab that protrudes through the calibration switch/button cover
5. Continue to thread the wire through the wire lock at the other end forming a loop (see Figure 64).
6. Crimp the lock closed to secure the wire.
7. Insert the tab on the end of the transparent cage cover into the slot on the end of the MS2420 unit then
snap the other end into place over the tab on the MS2420 unit.
8. Reinstall the platter.
Figure 64. Calibration Switch/Button Wire Security Seal Assembly.