Filter
Top Products
User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router 4 Web-based Management
21
Figure 4-8 Edit iplan interface
To configure the routes, click the label to open the route configuration page.
To edit routes, refer to 4.6 Route.
To create a new virtual interface, click Create a new virtual interface to enter the
Create virtual interface page. Input an IP address for the virtual interface and/or a
subnet (Note that the IP address of the virtual interface must not belong to the same
subnet as that of the LAN interface), and then press Apply to enable it. Refer to 6.1 IP
Addresses for more information about IP address. The virtual interface created here
can be used for DMZ configuration. Refer to 4.8 DMZ Configuration for more
information.
To edit the current virtual interface, click <Edit…>. Then in the new page, change the
settings if necessary, and press <change> to confirm your changes.
To delete the current virtual interface, click <Delete…>. Then in the new page, click
<Delete this connection…> to confirm your deletion.
& Note:
Only after the user has created a virtual interface can you create a new security
interface in Security Interface Configuration page, refer to 4.7 Security Interface for
more information.
4.5 DHCP
As a DHCP server, the unit maintains a pool of IP addresses and distributes them to
LAN hosts whenever those hosts are switched on.