Filter
Top Products
User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router 8 Troubleshooting
65
8 Troubleshooting
This chapter suggests solutions to problems you may encounter in installing or using
the ADSL router, and provides instructions for using several IP utilities to diagnose
problems.
Contact Customer Support if these suggestions do not resolve the problem.
8.1 Troubleshooting Suggestions
Table 8-1 Troubleshooting suggestions
Problem Troubleshooting Suggestion
LEDs
Power LED
does not
illuminate
Verify that you are using the power cable provided with the device
and that it is securely connected to the ADSL router and a wall
socket/power strip.
Link LED does
not illuminate
after phone
cable is
attached.
Verify that a standard telephone cable (called an RJ-11 cable) like
the one provided is securely connected to the DSL port and your
wall phone port.
LINK LAN LED
does not
illuminate after
Ethernet cable
is attached.
Verify that the Ethernet cable is securely connected to your LAN
hub or PC and to the ADSL router. Make sure the PC and/or hub
is turned on.
Verify that you are using a straight-through Ethernet cable to the
uplink port on a hub or a cross-over cable to a stand-alone PC. If
you connect the device to an ordinary hub port (not uplink), you
must use a straight-through cable. (To check: hold the connectors
at each end of the cable side-by-side with the plastic spring facing
down. Looking at the wires from left to right, if the first, second,
third, and sixth wires are in the same color on the two connectors,
then it is a straight-through cable. For a cross-over cable, wire 1
on one connector should be in the same color as wire 3 on the
other. The same is true with wires 2 and 6.)
Verify that your cable is sufficient for your network requirements.
A 100 Mbps network (10BaseTx) should use cables labeled CAT
5. A 10Mbps network may tolerate lower quality cables.
Internet Access