Filter
Top Products
Configur
a
49
This parameter is used to enable or disable the IP routing function. If IP routing is disabled, bridging
must be enabled for IP packets to be forwarded through the router. Bridging is rarely used as the
protocol for Internet access.
IP Address of Remote Ethernet
The remote IP address is the IP address of the remote router located at your ISP site. The IP address is
entered in the standard IP address format of a.b.c.d. The remote IP address is required during PPP
negotiation. Please ask your ISP if you don’t possess one.
IP Mask of Remote Ethernet
The remote IP mask is used to describe the remote IP sub-netting. The IP mask is entered by clicking the
IP address bit map. The number of bits assigned for the IP subnet is shown next to the IP address bit map
as a decimal number for your reference.
Local End IP Address of ISDN Line
This field specifies the local end of the IP address of an IP connection. This field is applicable to the
“numbered interface” IP address setting.
Remote End IP Address of ISDN Line
This field specifies the remote end of the IP address of an IP connection. This field is applicable to the
“numbered interface” IP address setting.
IP Mask of ISDN Line
This field specifies the IP mask of the ISDN line when the “numbered interface” IP address scheme is
used. Both local end and remote end should use the same IP mask.
Intranet IPX Menu
The Intranet IPX sub-menu is shown in Figure 0-14, Intranet IPX Window. This menu is used to
configure an IPX connection on an Intranet.