Filter
Top Products
6 REPLACEMENT: COMPONENT AND
SUB-ASSEMBLY
6.1 TASK -- REMOVING SCANNER COVERS AND PANELS
Equipment, Tools & Materials Required:
• 5/32 inch Allen wrench
• Standard Flat-head Screwdriver
Procedure to Remove the Front Cover:
1. Use a 5/32” Allen wrench to open the two latches on front cover, then tilt the cover out -
- top first.
2. Disconnecting the earth-ground wire connecting the front cover and the frame.
3. Lift the cover up and out to clear the two small pins on the bottom edge of the cover
from the sockets they fit into.
Procedure to Remove Either Side Panel:
1. Lift up the lid of the scanner.
2. Remove the front cover first (see preceding instructions).
3. Loosen the two screws that fasten the panel to the front of the scanner frame.
4. Loosen the two screws that fasten the panel to the rear of the scanner frame.
5. Pull the panel out horizontally.
Procedure to Remove the Back Panel:
1. Remove the two screws above the electrical connector panel.
2. Loosen each of the eleven screws holding the back cover panel in place.
3. Swing the top of the panel out. Disconnect the power supply to the back panel fans.
4. Lift off the back panel.