IBM i Series 1200 Laptop User Manual


 
Notices
2. the application using the modem is compatible with the appli-
cation at the other end of the call - e.g. accessing the
Internet requires suitable software in addition to a modem.
Some parameters required for compliance with Telecom's Tele-
permit requirements are dependent on the equipment (PC) asso-
ciated with this device. The associated equipment shall be set to
operate within the following limits for compliance with Telecom's
Specifications:
1. There shall be no more than 10 call attempts to the same
number within any 30 minute period for any single manual
call initiation.
2. The equipment shall go on-hook for a period of not less than
30 seconds between the end of one attempt and the begin-
ning of the next attempt.
3. Where automatic calls are made to different numbers, the
equipment shall go on-hook for a period of not less than 5
seconds between the end of one attempt and the beginning
of the next attempt.
4. The equipment shall be set to ensure that calls are answered
between 3 and 30 seconds of receipt of ringing (S0 set
between 2 and 10). This ensures:
a. a person calling your modem will hear a short burst of
ringing before the modem answers. This confirms that
the call has been successfully switched through the
network.
b. caller identification information (which occurs between
the first and second ring cadences) is not destroyed.
The preferred method of dialling is to use DTMF tones (ATDT...)
as this is faster and more reliable than pulse (decadic) dialling. If
for some reason you must use decadic dialling, your communi-
cations program must be set up to record numbers using the fol-
lowing translation table as this modem does not implement the
New Zealand "Reverse Dialling" standard.
Number to be dialled: 0 1 2 3456789
Number to program into
computer:
0987654321
Appendix B. Product warranties and notices 143