Filter
Top Products
Property Name Possible
values
Default
value
Update
method
Notes
SynchronousRequestQueue CONNECTORNAME/
SYNCHRONOUSREQUESTQUEUE
component
restart
“SynchronousResponseQueue” on
page 52
CONNECTORNAME/
SYNCHRONOUSRESPONSEQUEUE
component
restart
SynchronousRequestTimeout 0 component
restart
“WireFormat” on page 53 CwXML, CwBO cwxml agent restart CwXML for
non-ICS broker;
CwBO if
Repository
Directory is
<REMOTE>
AdminInQueue
The queue that is used by the integration broker to send administrative messages
to the connector.
The default value is CONNECTORNAME/ADMININQUEUE.
AdminOutQueue
The queue that is used by the connector to send administrative messages to the
integration broker.
The default value is CONNECTORNAME/ADMINOUTQUEUE.
AgentConnections
The AgentConnections property controls the number of IIOP connections opened
for request transport between an application-specific component and its connector
controller. By default, the value of this property is set to 1, which causes
InterChange Server to open a single IIOP connection.
This property enhances performance for a multi-threaded connector by allowing
multiple connections between the connector controller and application-specific
component. When there is a large request/response workload for a particular
connection, the IBM WebSphere administrator can increase this value to enhance
performance. Recommended values are in the range of 2 to 4. Increasing the value
of this property increases the scalability of the Visigenic software, which establishes
the IIOP connections. You must restart the application-specific component and the
server for a change in property value to take effect.
Important: If a connector is single-threaded, it cannot take advantage of the
multiple connections. Increasing the value of this property causes the
request transport to bottleneck at the application-specific component.
To determine whether a specific connector is single- or multi-threaded,
see the installing and configuring chapter of its adapter guide.
AgentTraceLevel
Level of trace messages for the application-specific component. The default is 0.
The connector delivers all trace messages applicable at the tracing level set or
lower.
Appendix A. Standard configuration properties for connectors 37