Filter
Top Products
The default value is false.
OADMaxNumRetry
Specifies the maximum number of times that the OAD automatically attempts to
restart the application-specific component after an abnormal shutdown.
The default value is 1000.
OADRetryTimeInterval
Specifies the number of minutes of the retry time interval that the OAD
automatically attempts to restart the application-specific component after an
abnormal shutdown. If the application-specific component does not start within the
specified interval, the OAD repeats the attempt as many times as specified in
“OADMaxNumRetry”.
The default is 10.
PollEndTime
Time to stop polling the event queue. The format is HH:MM, where HH represents
0-23 hours, and MM represents 0-59 seconds.
You must provide a valid value for this property. The default value is HH:MM, but
must be changed.
PollFrequency
The amount of time between polling actions. Set PollFrequency to one of the
following values:
v The number of milliseconds between polling actions.
v The word key, which causes the connector to poll only when you type the letter
p in the connector’s Command Prompt window. Enter the word in lowercase.
v The word no, which causes the connector not to poll. Enter the word in
lowercase.
The default is 10000.
Important: Some connectors have restrictions on the use of this property. To
determine whether a specific connector does, see the installing and
configuring chapter of its adapter guide.
PollStartTime
The time to start polling the event queue. The format is HH:MM, where HH represents
0-23 hours, and MM represents 0-59 seconds.
You must provide a valid value for this property. The default value is HH:MM, but
must be changed.
RequestQueue
The queue that is used by the integration broker to send business objects to the
connector.
The default value is REQUESTQUEUE.
44 Adapter for i2 User Guide