Filter
Top Products
Attention:
v WebSphere MQ Integrator supports only one locale at a time. Ensure that every
component of the installation (for example, all adapters, applications, and the
integration broker itself) is set to the same locale.
v If the connector has not been internationalized, the only valid value for this
property is en_US. Do not run a non-internationalized C++ connector against
InterChange Server version 4.1.1 if you cannot guarantee that only ISO Latin-1
data will be processed. To determine whether a specific connector has been
internationalized, see the installing and configuring chapter of its connector
guide.
MessageFileName
The name of the connector message file. The standard location for the message file
is \connectors\messages. Specify the message filename in an absolute path if the
message file is not located in the standard location. This property defaults to the
value InterchangeSystem.txt for new connector definitions and should be changed
to the name of the message file for the specific connector.
PollEndTime
Time to stop polling the event queue. The format is HH:MM, where HH represents
0-23 hours, and MM represents 0-59 seconds.
You must provide a valid value for this property. The default value is HH:MM, but
must be changed.
PollFrequency
The amount of time between polling actions. Set the PollFrequency to one of the
following values:
v The number of milliseconds between polling actions.
v The word key, which causes the connector to poll only when you type the letter
p in the connector’s Command Prompt window. Enter the word in lowercase.
v The word no, which causes the connector not to poll. Enter the word in
lowercase.
The default is 10000.
Important: Some connectors have restrictions on the use of this property. To
determine whether a specific connector does, see the installing and
configuring chapter of its adapter guide.
PollStartTime
The time to start polling the event queue. The format is HH:MM, where HH represents
0-23 hours, and MM represents 0-59 seconds.
You must provide a valid value for this property. The default value is HH:MM, but
must be changed.
RepositoryDirectory
The path and name of the directory from which the connector reads the XML
schema documents that store the meta-data of business object definitions.
The default value is C:\crossworlds\repository. You must change this to the
directory path that you are using for the \repository directory for your connector.
Typically that path is established when you install the adapter product; for
Appendix A. Standard configuration properties for connectors 51