InFocus IN5554L Projector User Manual


 
47
Control commands
IMPORTANT: When formatting commands sent from a control system or computer, enclose
commands in parentheses “(“ and “)”.
Serial Communication Configuration
Visit our website for additional R
S-232 settings and information.
To control this projector via RS-232, connect a straight through cable and set the control
s
ystem serial port settings to match the following communication configuration
:
RS-232 Port Settings
Setting Value
Bits per second 38,400
Data bits 8
Parity None
Stop bits 1
Flow control None
Emulation VT100
Network Communication Configuration
For network control, you can access the projector through Port 23 (Telnet).
We use the same control codes on serial as we do over the network. InFocus network control
use
s the Telnet packet structure.
Command Format
All commands consist of 3 alpha characters f
ollowed by a request, all enclosed in
parentheses. The request can be a read request (indicated by a "?") or a write request
(indicated by 1 to 4 ASCII digits).
A read request example:
(AAA?) where
(starts the command
AAA denotes the command
? denotes the read request
) ends the command
A read command returns the range and the current setting, for example
:
Read Command Examples
Function Command Response
Brightness (BRT?) (0-200, 100)
Lamp Hours (LMP?) (0-32766, 42)
A write request example:
(AAA####) where
(starts the command
AAA denotes the command
#### denotes the value to be written
(leading zeros not necessary)
) ends the command
Some commands have ranges, while others are absolute. If a number greater than the
maxim
um range is received, it is automatically set to the maximum number for that function.
If a command is received that is not understood, a "?" is returned. With absolute settings, "0"
is off, 1-9999 is on. The one exception is the Power command, where 0 is off and 1 is on.
To assure the projector can process a command, wait 3 seconds before entering the next
c
ommand.
Write Command Examples
Function Command Response
Brightness (BRT100) Sets the brightness to
10
0
Power (PWR0) Turn s power off
Power (PWR1) Turn s power on