InFocus LP260 Projector User Manual


 
4
Introduction
Usage Guidelines
Do not look directly into the projection lens when the lamp is
turned on. The bright light may harm your eyes.
Do not block the grills on the projector. Restricting the air flow
can cause it to overheat and turn off. If this happens, you must
wait a minute before attempting to turn it back on.
Handle the projector as you would any product with glass
components. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold
for extended periods of time. If this happens, allow it to reach
room temperature before use.
Transport the projector in a vendor-approved hard or soft case.
Part numbers for these cases are listed on page 45.
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in “Troubleshooting” on page 39. Or, check the
Service and Support section of our website at
http://www.infocus.com/service.
You’ll find a Technical Library,
FAQs, and support contacts including a technical support e-mail
form.
If those sources don’t answer your question, call your InFocus
dealer. You can also call InFocus Customer Service directly at
1-800-799-9911
. Call between 6 a.m. and 6 p.m. PST, Monday
through Friday. Service is available in North America after hours
and on weekends for a fee at 1-888-592-6800.
In Europe, call InFocus in The Netherlands at
(31) 35-6474010
.
In Asia, call InFocus in Singapore at
(65) 332-0659
.
Or, send us an e-mail at
techsupport@infocus.com
Our World Wide Web address is
http://www.infocus.com
.
Warranty
This product is backed by a limited two-year warranty. The
details of the warranty are printed at the back of this manual. A
longer term warranty can be purchased from your InFocus
dealer. Refer to page 45 for the part number.