InFocus LP260 Projector User Manual


 
39
Troubleshooting
Problem: The projector is not running
Make sure that the power cord is properly connected to a fully
functional AC electrical outlet. Make sure that the power cord
is also properly connected to the projector.
If the projector is plugged into a power strip, make sure the
power strip is turned on.
Make sure the projector is turned on.
Problem: Projector is running, but nothing appears on projec-
tion screen
Make sure you have removed the lens cap on the projection
lens at the front of the projector.
Check the projector’s lamp to ensure that it is securely con-
nected in the lamp module. Make sure the lamp cover is
installed. See “Replacing the Projection Lamp” on page 36.
Problem: Only the start-up screen displays
Verify that the cables are connected correctly. See page 7 and
page 8 for connection procedures.
Make sure that the cables do not have any bent pins.
Verify that the proper input source is connected. See “Source
(keypad only) or Computer and Video (remote only)” on
page 16.
You might need to turn everything off and power up the
equipment again in the proper order. Refer to your com-
puter’s documentation to determine the correct order.
Make sure your laptop’s external video port is turned on. See
the “Portable and Laptop Activation Chart” on page 46 or
your computer’s manual for details.
Make sure your computer’s video board is installed and con-
figured correctly.
Make sure your computer has a compatible video board. The
projector isn’t CGA or EGA compatible.