Filter
Top Products
26
Using the Projector
Video Adjustments
Select Video mode by pressing the
source
button on the keypad,
pressing the
video
button on the remote, or clicking the video icon
in the menu.
Video Source menu
The projector automatically detects the signal from any con-
nected video sources. If more than one source is connected, use
the Video Source menu to select the desire one.
1
Press the
menu
button, navigate to the Video Source menu,
then press the
select
button.
The “Video Source” menu appears.
2
Press the
point
down
button and position the red arrow by the
desired source.
NOTE: When both the Video and
S-Video jacks are connected, the
S-video jack input is displayed.
When both the Y-Pb/Cb-Pr/Cr and
S-Video jacks are connected, the
Y-Pb/Cb-Pr/Cr jack input is
displayed.
Auto
In this mode, the projector automatically detects the incoming
video source and adjusts itself to optimize performance.
Video/S-Video/Y, Pb/Cb/Cr
When more than one video source is connected and the projector
cannot select the proper video source, select the desired source in
the menu.
source menu