Filter
Top Products
IrDA Infrared Interface Port (CN6)
The built-in IrDA port supports Serial Infrared (SIR) or Amplitude Shift Keyed IR
(ASKIR) interface. To use the IrDA port, configure the SIR or ASKIR model in the
BIOS's Peripheral Setup's COM2. Then, the normal RS-232 COM2 will be disabled.
For the location of this connector, refer to figure 2.
Pin Number Description
1 VCC
2 FIR-RX
3 IR-RX
4 GND
5IR-TX
6 CIR-RX
VGA Connector (J1)
The built-in 15-pin VGA connector can be connected directly to your monochrome
CRT monitor as well as a high resolution color CRT monitor. For the location of
this connector, refer to figure 2.
Pin Number Description
1RED
2 GREEN
3BLUE
4NC
5 GND
6 GND
7 GND
8 GND
9 VCC
10 GND
11 NC
12 DDC DATA
13 HSYNC
14 VSYNC
15 DDC CLK
Board Configuration 22