Filter
Top Products
PCI/PLUG AND PLAY SETUP
This setup handles the SBC-370 PCI function. All PCI bus slots on the system use
INTA#, thus all installed PCI slots must be set.
Plug and Play Aware O/S >:
When PNP OS is installed, interrupts will be reassigned by the
OS when the setting is
Yes. When a non-PNP OS is installed or to prevent reassigning
of interrupt settings, set the setting to
No.
Clear NVRAM >: Specify whether or not the BIOS will clear NVRAM on every boot.
PCI Latency Timer (PCI Clocks) >: Define the latency timing (PCI clock) for all PCI devices on
the PCI bus.
PCI VGA Palette Snoop >: This option is useful only for a system with more than one VGA
device connected to it through different bus (one PCI and one ISA). To enable those
various VGA devices to handle signals from the CPU on each set of palette registers of
every video device, it must be set to
Enabled.
Note: If another PCI or ISA video card is needed other than the onboard VGA, set PCI
VGA Palette Snoop
to Enabled. The system will automatically recognize and use the additional
video card when
Enabled.
Allocate IRQ to PCI VGA >: To allocate IRQ to PCI VGA, select Yes.
PCI IDE BusMaster >: Used to include the BusMastering capability into the IDE Controller
on the PCI.
33 AMI BIOS Setup Menus