Filter
Top Products
Offboard PCI IDE Card >: This function is used to specify whether or not an offboard PCI
IDE card is installed in your computer. You must specify the slot number on the board
which will be used for the card.
Offboard PCI IDE Primary (/Secondary) IRQ >: Specify the PCI interrupt that is assigned to the Pri
-
mary (/Secondary) IDE channel on the offboard PCI IDE controller.
PCI Slot (1,2,3,4) IRQ Priority >: Specify the IRQ priority to be used by the PCI devices on slots
1to4.
DMA Channel (0,1,3,5,6,7) >: Used to indicate whether or not the DMA channel is assigned for
a PnP or ISA card.
IRQ (3,4,5,7,9,10,11,14,15) >: Assign the displayed IRQ to be used by a legacy ISA adapter
card. The settings are
ISA/EISA or PCI/PnP.
PERIPHERAL SETUP
This setup works mostly on Multi-I/O Chip (W83977F). The options are used to
change the Chipset's registers. Carefully change any default setting to meet your
application needs. The only concern is Onboard Serial Port 2. If you want to use
the IrDA port, you have to configure the SIR or ASKIR model in the BIOS's Periph
-
eral Setup's COM2; the RS-232 COM2 will be disabled.
Onboard FDC >:
Used to enable the FDC on your board. If you set it to Auto, the BIOS will
automatically decide if the FDC should be enabled.
Onboard Serial Port A (/B) >: Specify the I/O port address of the serial port 1(/2). If you set it
to
Auto, the BIOS will decide the correct I/O port address automatically.
AMI BIOS Setup Menus 34