Filter
Top Products
Floppy Drive Swap >: This function enables you to swap the floppy disk drives through
software without moving the hardware.
Floppy Drive Seek >: When this option is Enabled, the BIOS will perform a Seek command
on floppy drive A: before boot-up.
PS/2 Mouse Support >: This is used to determine whether or not a PS/2 mouse is supported.
System Keyboard >: Configures the keyboard. If you set it to Absent, the BIOS will not re
-
port keyboard errors.
Primary Display >: Used to define the type of display monitor for the system. The Absent
option is for network file servers.
Password Check >: Used to define whether or not a password is necessary for access to the
BIOS setup.
Boot to OS/2 >: If you run the OS/2 operating system, this option must be set to Yes, per
-
mitting the BIOS to run properly if OS/2 or any other OS that does not support Plug
and Play is found in your computer.
CPU Serial Number> : This option is available only if you use a Pentium® III processor.
Cache Bus ECC >: This option is available only if you use a Pentium® III processor.
System BIOS Cacheable >: Used to define whether or not the memory segment FOOOH can
be read from or written to cache memory. Setting it to
Enabled will provide faster execu-
tion in your system.
XXXX, 16k Shadow >: ROM Shadow is a technique in which BIOS code is copied from
slower ROM to faster RAM. If you enable it, the BIOS will be executed from the RAM.
Each option allows 16 K segment to be shadowed to the RAM.
29 AMI BIOS Setup Menus