Filter
Top Products
61
Appendix A
PPTP VPN (W2K and XP only)
Important:
Make sure that the subnet of your Appliance is different the network you are
trying to connect from. For example: User’s office IP addresses are
192.168.1.x, set your Appliance to 192.168.2.1 Netmask 255.255.255.0.
Make sure that you have created a user account and password on the
Appliance for the users that you want to allow VPN access.
Proceed to your appliance’s PPTP Settings under VPN Settings.
1. Enable the Server
2. Enter a server IP, a number from 2-254 that is not being used by any
computer on the Appliance network. Usually 200 is a safe number.
3. Enter a range of IP addresses that users logging into the Appliance will
be assigned. Usually 201-210 is ok. Again make sure that there are no
computers on the Appliance network using the IP addresses in this
range.
4. Select Apply.
From the remote computer:
1. From the start menu: Select Settings -> Network and Dial-up
Connections -> Make a new connection.
2. Click Next on the wizard and select Connect to a private network
through the internet. Click on Next.
3. Select Do not dial…..Click Next
4. Enter the host name. This should be a static IP if you have one. If not,
then set up a DDNS account before continuing. This is where the
Appliance can be found on the Internet. Click Next.
5. Select if you want to create this connection for all users on your
remote network or just for the one computer. Click Next.
6. Name your connection and select if you want to have an icon on your