Filter
Top Products
1. Start the AOL for Windows communication software. NOTE: Only
Version 2.5, 3.0 or later will work.
2. Click “Setup.”
3. Select “Create Location” and change the location name from “New
Locality” to “Wireless Router.”
4. Click “Edit Location”; select “TCP/IP” in the Network eld. (Leave the
“Phone Number” eld blank.)
5. Click “Save,” then “OK.” Conguration is complete. NOTE: Before clicking
“Sign On,” ensure you’re using the “Wireless Router” location.
macintosh
1. Open the TCP/IP Control Panel.
2. Select “Ethernet” from the “Connect via” pop-up menu.
3. Select “Using DHCP Server” from the “Congure” pop-up menu. The
“DHCP Client ID” eld can be left blank.
4. Close the TCP/IP panel, saving your settings.
NOTE: If using manually assigned IP addresses instead of DHCP, enter
the router’s IP address in the “Router Address” eld and ensure the
DNS settings are correct.
linux
1. Set the Wireless G Broadband Travel Router as the “Gateway.” NOTE:
Ensure you are logged in as “root” before attempting any changes.
To continue using a xed IP address (by default, most Unix installations
use a xed IP address), enter the router’s IP address in the “Default
Gateway” eld and ensure the DNS settings are correct.
To act as a DHCP client (recommended), follow the steps below. NOTE:
This procedure may vary depending on the version of Linux and the X
Window shell.
1. Start the X Window client.
2. Go to Control Panel ‡ Network.
3. Select the Interface entry for your network card (normally, “eth0”).
4. Click “Edit”; set the Protocol to “DHCP”; save this data.
NOTE: To apply the changes, use the “Deactivate” and “Activate”
buttons, if available, or restart the system.
COMPUTER CONFIGURATION
41