Filter
Top Products
9.
Install the grounding clip.
• The clip slides over one wall of the top chassis. Make sure
the grounding clip also touches the CPU card heat sink.
NOTE: If your Mac does not have a Grounding Strap,
ignore this step.
Installing the grounding clip
Cutaway view of the installed grounding clip
Chapter 2 - Installing the MACh Speed G3 Upg rade Car d
Page 17
8. Install the MACh Speed G3 into your system.
IMPORTANT: Handle by the edges only! Do not push
down on the heat sink. Doing so may damage the card
and/or computer. Excessive force is not needed to seat the
card. if steady, gentle pressure does not work, pull the
card out and insert again.
• The MACh Speed G3 Upgrade will face the same direc-
tion as the older card that you just removed. In most cases
this is with the heat sink towards the Power Supply. The
connector is designed to fit only one way.
•Holding the card by the edges (do not depress the heat
sink), insert, into the connector without twisting or rock-
ing.
• You may feel the card going into the slot in two stages: the
first row of contacts slides in, and then the second row. Be
sure that you push the card all the way into the slot.
• When the card is properly installed, you cannot see any of
the gold contacts.
Installing the MACh Speed G3 Upgrade Card
Chapter 2 - Installing the MACh Speed G3 Upg rade Car d
Page 16
expansion
wall
MACh Speed G3
Upgrade Card
clip attached
to wall
clip contacts card
and wall