Filter
Top Products
5. Install the MACh Speed G3 into your system.
• The MACh Speed G3 Upgrade will face the same direc-
tion as the older card that you just removed. In most cases
this is with the heat sink towards the Power Supply. The
connector is designed to fit only one way.
•Holding the card by the edges (do not depress the heat
sink), insert into the connector without twisting. You may
feel two distinct “clicks” as the card seats itself firmly into
the connector.
Installing the MACh Speed G3
6. Boot your Mac to test the Card/installation.
• At this point, it is a good idea to check that you get a suc-
cessful boot up “chime”, ensuring that the card is well
seated and working.
• Simply plug the power cord into the Mac, and start up
the Mac. Once you have verified the “chime, you can dis-
connect power, and complete the card installation. If you
do not hear a “chime”, refer to Chapter 5 - Tech Support.
•Note: On some machines it may be mandatory to reassem-
ble the Mac before booting. It is suggested that you test for
a successful start-up “chime” at the earliest period possible
to streamline any troubleshooting that may later be
required.
Chapter 1 - QuickStart
Page 5
Chapter 1 - QuickStart
Page 4
3. Remove the existing CPU card.
• Identify the location of the CPU card. You can refer to
the later chapters, or to your Systems user manual.
Removing the CPU card from a PowerMacintosh 7300
4. Remove the MACh Speed G3 from its protective package.
• Be sure that you are grounded, and remove the
MACh Speed from its protective package.
• Inspect the card for any irregularities or possible damage
in shipment.
Inspecting the MACh Speed G3