JVC HD-61G587 Computer Monitor User Manual


 
64
Lamp Replacement
WARNING!
Remember it is very important that YOU DO NOT TOUCH THE LAMP SURFACE. Please
read the warnings on page 61 again.
Also, replace the lamp with part number TS-CL110U only! The monitor is designed
to work specifically with this lamp. Lamps other than TS-CL110U may cause
malfunctions and/or other damage to the monitor.
To purchase a replacement lamp kit, please call 1-800-252-5722.
NOTICE (for USA)
This product has a High Intensity Discharge (HID) lamp that
contains a small amount of mercury. It also contains lead in some
components. Disposal of these materials may be regulated in your
community due to environmental considerations. For disposal or
recycling information, please contact your local authorities, or the
Electronics Industries Alliance: http://www.eiae.org
T
5) Install the new lamp unit.
Holding the handle attached to the new lamp unit, slide and push the new lamp straight into the
monitor and back into the lamp housing area. Do not forget to re-tighten the two screws.
Note: If the lamp does not sit securely in the monitor (flat in the lamp housing area), it won’t
turn on. Make sure the lamp sits securely and flat in the housing area.
6) Re-install the lamp cover.
Insert the lamp cover in the right concave and close the lamp cover. Because the lamp cover
has a role to help prevent the danger of an electrical shock, tighten the screw using your
fingers.
Note:
• After installing the new lamp unit, do not forget to reset the lamp timer. See page 51.
LCT2065-001B-A ENG.indd 64LCT2065-001B-A ENG.indd 64 12/18/06 10:11:13 AM12/18/06 10:11:13 AM