Filter
Top Products
33
Auto SP/LP Timer
If, when recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
12
45
3
6
8
0
7
9
2
1
3
6
q
PDC Recording
Now available from some TV stations, PDC (Programme
Delivery Control) is a service designed to assure safe, accurate
timer recording. With this system, special code signals are
transmitted together with the audio/video signals. These code
signals control your video recorder and have precedence over
advertised times you preset in the timer. This means that your
recorder will start and stop recording when the preset TV
programmes actually start and end — even if the broadcast time
of a preset TV programme is changed.
To Use PDC Service . . .
The default setting for PDC is "ON". To cancel PDC, press :
PDC (NUMBER key “7”) so that "OFF" is displayed during Video
Plus+ or regular timer programming.
NOTES:
●
When you manually enter programmes (regular timer
programming), set the start time (PDC time) exactly as
advertised in the TV listing. A different time than advertised
will result in no recording.
●
PDC Recording is also possible when a satellite tuner or a
cable box is connected to AV2 IN on your recorder.
●
When PDC recording is performed, the Instant ReView
programme readout number may not match the actual number
of programmes that have been timer-recorded (
੬
pg. 14).
AUTO SP/LP TIMER
ENGAGE AUTO SP/LP
TIMER
1
Press AUTO SP/LP TIMER on the recorder front panel.
The button lights “green”.
For Example . . .
Recording a program of 210 minutes in length onto a
180-minute tape
Make sure you press AUTO SP/LP TIMER before
performing timer programming.
NOTES:
●
The Auto SP/LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 as well as some
tapes of shorter lengths.
●
Even if, in step 1, you press AUTO SP/LP TIMER and it lights
“green”, that doesn’t mean that the recorder will automati-
cally change from SP to LP mode during the course of the
recording. Watch the tape later to confirm.
●
If you have programmed the recorder to timer-record 2 or
more programs, the second programme and those thereafter
may not fit on the tape if you engage the Auto SP/LP Timer
mode. In this case, make sure the mode is not engaged, then
set the tape speed manually during timer programming.
●
There may be some noise at the point on the tape where the
recorder switches from SP to LP mode.
●
If you perform timer recording with both PDC and the Auto
SP/LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
Total 210 minutes
Approximately 150 minutes Approximately 60 minutes
SP mode
LP mode
: PDC