Filter
Top Products
19
4.6. Software Installation and Settings
Install the software required for KNS operations on the host station PC and the remote
station PC, then perform the required settings.
● Host station PC
Download and install the ARHP-990 onto the PC from the KENWOOD website:
http://www.kenwood.com/i/products/info/amateur/software_download.html
Connect the PC and TS-990S using a USB or RS-232C cable. Then, turn ON the
TS-990S.
After starting the ARHP-990, make the COM port settings used to connect to the TS-990S,
network settings, optional settings, and user settings by selecting the "Tool" menu and
then "Setup" in the ARHP-990. For the setting methods, refer to the ARHP-990 help file.
Additionally, in "Configure KNS" in the "Tool" menu, set a user account, whether or not to
use the VoIP function and others.
On the remote operation within the home LAN area, the VoIP function built into the
ARCP-990 and ARHP-990 can be used. In this case, in "Configure VoIP" in the "Tool"
menu of ARHP-990, select the audio device that is connected with an audio cable to the
TS-990, as the audio device to be used in VoIP.
Caution:
Names in the selection of the device depend on the PC. For each setting, refer to
the help file of the ARHP-990.
On the remote operation via the internet, install the VoIP Program. If you select to use the
ARVP-10 as a VoIP program, download it from the KENWOOD website:
http://www.kenwood.com/i/products/info/amateur/software_download.html
The ARVP-10 is included with the ARVP-10H for the host station and the ARVP-10R for
the remote station.