Filter
Top Products
30
Question
Answer
Operations
The audio transmission keeps
varying in volume and is not
constant.
Has the AGC been turned ON using the
VoIP software input audio settings?
For details, refer to the VoIP software
user manual, and check the settings.
The final part of the audio
transmitted from the host station
transceiver is missing.
If you return to receiving operations
immediately after the conversation has
finished using the remote station, you
may switch to receiving before all the
audio has been transmitted due to the
audio transmission delay.
In such cases, on the ARCP-990, select
"Select Modulation Line" in the "TX/RX"
menu, and set a slightly longer time in
"Delay by TX to RX Transition” when
“During KNS Connection".
Cannot hear the transmit monitor
audio from the speakers of the PC
at the remote station.
Several VoIP Programs have
specifications that will shut off the voice
from the other side while sending voice
from this side. With a VoIP Program like
this, you cannot hear the transmit
monitor audio properly.
When selecting a tuning step other
than "Preset", reaction may be
delayed during KNS operations.
When set to other than "Preset", the
network is more easily delayed than
when using "Preset" due to the
difference in the internal commands. In
such cases, either select "Preset" and
perform tuning, or change the frequency
using the "MULTI/CH" operation.
Comprehe
nsive
security
software,
etc.
I'm using comprehensive security
software, but when I try a KNS
connection, the warning "Software
is attempting to connect to the
internet" is displayed. Can I press
the "Block" button?
Refer to the user manual for the
comprehensive security software being
used, and set it so that the
communications of the port used by the
ARCP-990, ARHP-990 and VoIP
Program are not blocked.