Filter
Top Products
28
Question
Answer
Operations
Cannot hear the received
transceiver audio from the speaker
of the PC at the remote station.
Audio output level from the TS-990S
may be too low. Refer to "Audio I/O level
settings" in "4.3. Transceiver Settings"
of this document, and adjust each
output level.
On the ARHP-990, check that the
setting of the VoIP output device is not
wrong.
If several sound devices are connected
to the PC of the remote station, check
that the desired sound device has been
selected as the output destination of the
VoIP, in "Configure VoIP" of the
ARCP-990.
Cannot hear the received sub-band
audio from the speakers of the PC
at the remote station.
Refer to "Audio output configuration" in
"4.3. Transceiver Settings" of this
document.
Audio transmissions are noisy or
small. Where should I check and
adjust?
Refer to "Audio I/O level settings" in
"4.3. Transceiver Settings" of this
document, and adjust each output level.
Try changing the sound function driver
version.
If using the sound functions in
comprehensive chipsets, try an
independent sound card or USB sound.
I want to hear the beeps and voice
guidance audio of the transceiver
from the PC speaker. Is this
possible?
Refer to "Mixed beep setting to external
audio outputs" in "4.3. Transceiver
Settings" of this document, and set to
"Received Audio Only".
Can I set the PC to sleep mode
while I'm not using the host station?
When a fixed time has elapsed
without the host station being used,
the host station PC screen turns
OFF, and responses to connection
requests from the remote station
cannot be made.
Recovery from sleep mode takes time.
During sleep mode recovery, responses
to the remote station cannot be returned
until there is a time out. Therefore, we
recommend you do not set the host
station to sleep mode.