Filter
Top Products
2
1. Relevant Models
This operations guide is for the TS-990S.
Using the TS-990S and the KENWOOD NETWORK COMMAND SYSTEM (hereinafter
called "KNS") enables transceiver operations by remote control using a home LAN or the
internet.
KNS is a system configured using PCs, network environments, ARCP-990 (a Radio
Control Program; hereinafter called "ARCP-990”), ARHP-990 (a Radio Host Program;
hereinafter called “ARHP-990”), and ARVP-10 (a VoIP Program; hereinafter called “VoIP
Program”) for remote control of the TS-990S.
Note: If the firmware version of the TS-990S is V1.00, please update it to V1.01 or later.
Important
To configure the system, knowledge not only of transceivers but also of PCs and
networks is required. JVC KENWOOD does not offer support for customer PCs
and Networks. Furthermore, for operations relating to actual transmitting, note that
procedures according to the Radio Act are also required.
Operations via networks may be delayed due to unavoidable principles.
Consequently, do not perform operations (such as contests or pile-ups requiring
quick responses) for which delays are likely to be a problem.
Even if you set by the procedures described in this document, the feature may
not work properly because of the combination of PC, the network environment
and the sound device.
Refer to “5. Limitations Caution!
” for other limitations.
JVC KENWOOD Corporation shall bear no responsibility for related damage such
as damage caused by missed communications and dialog opportunities due to
incorrect customer settings, nonconformances, or misoperations as a result of
using this document or the ARCP-990, ARHP-990 or ARVP-10 software.