Filter
Top Products
Troubleshooting
www.kodak.com/go/support
37
Nothing
happens when
you try to print
■ Check the power connections (page 3).
■ Remove the paper tray, check that paper is properly loaded, and re-install
(page 7).
■ If the Paper light glows steady amber, load paper (page 6).
■ Make sure the color cartridge is properly installed (page 4). If the Color
cartridge light is on, install a new cartridge.
Nothing
happens when
you try to print
(from docked
camera)
■ The camera is not properly seated on the connector. Reseat the camera
on the printer dock (page 10).
■ Re-establish the connection: remove, then reseat the camera on the
printer dock.
■ Make sure there is at least one picture in the camera’s internal memory
or memory card.
Nothing
happens when
you try to print
(from Kodak
card reader)
NOTE: The Kodak EasyShare printer dock series 3 is compatible with the Kodak 8-in-1
card reader and the Kodak 6-in-1 card reader (each sold separately). Other
Kodak USB card readers may work with the printer dock; however, other
manufacturers’ card readers are not supported.
■ Check the USB connections from the card reader to the printer dock
(page 14).
■ Re-establish the connection: disconnect, then reconnect the USB cable
from the card reader to the printer dock.
■ Make sure a memory card is inserted and that there is at least one
picture on the memory card.
Nothing
happens when
you try to print
(from PictBridge
compatible
device)
■ Check the USB connections from the PictBridge compatible device to the
printer dock (page 15).
■ Re-establish the connection: disconnect, then reconnect the USB cable
from the PictBridge compatible device to the printer dock.
■ Make sure there is at least one picture in the PictBridge compatible
device’s internal memory or memory card.
If... Try the following