Filter
Top Products
46 www.kodak.com/go/support
Troubleshooting
Still having problems?
Visit www.kodak.com/go/support, or see Chapter 8, Getting help, or contact your
camera manufacturer.
Transfer button/light
Light status Cause Action/solution
Light glows steady
green
The printer dock is ready for
transferring pictures.
None required.
Light blinks green Pictures are being transferred
to the computer.
None required.
After transferring pictures, the transfer
light continues to blink green until
either the Transfer button is pressed
again or the connection is no longer
available.
Light is off There are no pictures in the
camera or on the memory
card.
None required.
To enable Transfer:
1 Connect printer dock to computer
(page 23).
2 Take pictures.
3 Dock the camera, or connect a
compatible Kodak card reader
(page 14). If using a card reader,
make sure a memory card is
inserted.
The camera is not docked, a
compatible Kodak card reader
is not connected, or a memory
card is not inserted.
The printer dock is not
connected to the computer.
The camera is not properly
seated on connector.
Reseat the camera on the printer dock
(page 10).
The printer dock is printing in
standalone mode.
The Transfer button is disabled.
The computer is off. Turn on the computer.