Filter
Top Products
Problems When Sending Faxes66
Problems When Sending Faxes
If the fax cannot be sent correctly, refer to the following table, and then per-
form the indicated operation. If the fax still cannot be sent correctly, even after
performing the described operations, contact your technical representative.
" For details on the error messages, refer to “Error Messages on the
Message Window” on page 69. For details on troubleshooting proce-
dures for document misfeeds, paper misfeeds, poor print quality, or
empty consumables, refer to the Printer/Copier/Scanner User’s Guide.
Symptom Cause Solution
The document is not
scanned.
The document is too
thick, too thin or too
small.
Use the original glass to
send the fax.
The document is
scanned at an angle.
The document guides
are not adjusted to the
width of the document.
Slide the document
guides to fit the width of
the document.
The fax received by the
recipient is blurry.
The document is incor-
rectly positioned.
Position the document
correctly.
The original glass is
dirty.
Clean the original glass.
The text in the document
is written too faint.
Adjust the resolution
There may be a problem
with the telephone con-
nection.
Check the telephone
line, and then try send-
ing the fax again.
There may be a problem
with the recipient’s fax
machine.
Make a copy to check
that this machine is
operating correctly, and
then, if the copy was
printed correctly, have
the recipient check the
condition of their fax
machine.
The fax received by the
recipient is blank.
The document was sent
with the front side facing
down (when the ADF is
used).
Load the document to be
faxed facing up.