Filter
Top Products
Error Messages on the Message Window 69
Error Messages on the Message Window
Error message Cause Solution
LINE PROBLEM
(Flashing alter-
nately)
CHECK LINE
The telephone dialing
system or telephone
wiring system is not
set correctly.
The telephone cable
is not attached cor-
rectly.
Check the telephone dialing
system or telephone wiring
system and use the appropri-
ate configuration menu to
make the correct settings.
Correctly connect the tele-
phone cable.
*COMM.ERROR*
(####)
Communication is not
possible because of
some problem in the
machine.
Communication is not
possible because of a
problem with the
recipient/caller’s fax
machine.
Check the transmission results.
*REDIAL ALL FAILED* All redial attempts failed
because either the recip-
ient’s line is busy or
there was no answer.
Check the condition of the recipi-
ent’s line, and then try sending
the fax again.
*MEM.FULL/TX CAN-
CEL*
While sending a fax, the
size of the data for the
scanned image has
exceeded the capacity of
the memory.
Retrieve all received faxes stored
in the memory.
Send the fax by direct transmis-
sion.
To print an error report, press the
Cancel/C key while an error
message is displayed.
*MEM.FULL/RX CAN-
CEL*
While receiving a fax,
the size of the data for
the scanned image has
exceeded the capacity of
the memory.
Retrieve all received faxes stored
in the memory.
To print an error report, press the
Cancel/C key while an error
message is displayed.
HANG UP THE
PHONE
The receiver of the con-
nected telephone is
lifted.
Replace the receiver of the con-
nected telephone on the hook.