Kramer Electronics VS-88DTP Switch User Manual


 
VS-88DTP - Overview
7
VS-88DTPOverview 7
Figure 2: VS-88DTP 8x8 DVI - Twisted Pair Matrix Switcher Rear Panel
#
Feature
Function
14 IN 1 to IN 8 DVI Input Connectors Connect to the DVI sources
15 OUT 1 to OUT 8 RJ-45 TP Output
Connectors
Connect to the TP receivers (for example, PT-572HDCP+ and TP-574)
16 RS-232 9-pin D-sub (F) Connect to a PC or other serial remote controller
17 PROG TERM 2-way DIP-switch DIP-switch 1 Sets the RS-485 bus termination (see Section 5.2.2
DIP-switch 2 Sets the Programming mode. Only for the use of Kramer service personnel. Default = Off
) Up = Off, Down = On. Default = On
18 RS-485 3-pin Terminal Block
Connect to a serial controller or to another VS-88DTP unit.
Connect G to Ground, B to B, and A to A (see
Section 5.2
19
)
ETHERNET RJ-45 TP Connector Connect to a PC or LAN for remote control
20 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the device via an IR remote controller (instead of
using the front panel IR receiver)
21 MACH # DIP-Switch Sets the RS-485 bus machine number (see Section 5.2.1
22
)
RESET Button Press the reset button while turning the device on in order to reset the Ethernet factory default
definitions (see
Section 9
23
)
AC Power Receptacle Connect to the AC mains power supply
24 AC Mains Fuse AC mains supply protection fuse
25 AC Mains Power Switch Turns the AC mains power supply to the device on and off