Kramer Electronics VS-88DTP Switch User Manual


 
10 VS-88DTP - Connecting the VS-88DTP
5 Connecting the VS-88DTP
Always switch off the power to each device before connecting it to your
VS-88DTP. After connecting your VS-88DTP, connect its power and
then switch on the power to each device.
To connect the VS-88DTP as illustrated in the example in
Figure 3:
1. Connect up to eight DVI sources (for example, computer graphics sources)
to the IN 1 to IN 8 DVI connectors.
You do not have to connect all the sources.
2. Connect the OUT 1 to OUT 8 TP connectors to up to eight TP receivers (for
example, the PT-572HDCP+ and TP-574).
You do not have to connect all the outputs.
3. If required, connect a controller to the RS-232 (see Section 5.1) and/or
Ethernet port (see Section
5.3
4. Connect the power cord (not shown in
).
Figure 3).
5. If required, acquire the EDID (see
Section 6.5
i
).