Kyocera 8030 Copier User Manual


 
Basic Operation
3-3
NOTE: You can adjust the angle of the operation panel
as shown by releasing the operation panel lock lever.
After adjustment, lock the lever again.
When adjusting the angle of the operation panel, do
not place your hands or fingers underneath the
operation panel. This can result in injury.
6
Remove the finished copies from the output tray.
The output tray can hold up to 250 sheets of standard
paper (80 g/m²). However, the capacity will vary
depending on the type and condition of the paper.
When turning off the main power switch, press the
Power key on the operation panel to off ({). Make
sure that the Power lamp is off before turning off the
main power switch. Turning off the main power switch
before pressing the Power key to off may cause
damage to the equipped hard disk.
Caution
If the copier will not be used for a short period
of time (overnight, etc.), turn the main power
switch off ({ position). If it will not be used for
an extended period of time (vacations, etc.),
remove the power plug from the outlet for
safety purposes.