Kyocera FS-1100 All in One Printer User Manual


 
3 BASIC COPY MODES
72 Selecting Finishing Mode
Selecting Finishing Mode
Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher and Hole Punch Unit)
installed. Finishing devices available for this equipment are as follows:
Finisher
y Finisher DF-800
y Saddle Stitch Finisher DF-810
Hole Punch Unit
y Hole Punch Unit PH-6
Check the finishing modes enabled with each finishing device.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.74) Copies exit in the same page order as the originals one set after another.
Group ( P.74) Copies grouped by page exit.
Rotate sort ( P.75) Copies exit set by set alternately in a different direction.
Staple sort ( P.77) Copies exit with their corner stapled.
Magazine sort ( P.79) Copies exit in a book-type page order.
Saddle stitch ( P.79) Copies in a book-type page order exit with their center folded and stapled.
Magazine sort & saddle stitch
( P.79)
Magazine sort and saddle stitch are used together.
Hole punch ( P.81) Copies exit with their side punched.
Manual staple ( P.83) Copies are stapled manually.
Devices
Finishing mode
Sort/
Group
Rotate
sort
Staple
sort
Magazine
sort
Magazine
sort &
saddle
stitch
Saddle
stitch
Hole
punch
Manual
staple
DF-810 &
PH-6
Yes Yes Yes Yes Yes Yes Yes Yes
DF-810 Yes Yes Yes Yes Yes Yes Yes
DF-800 &
PH-6
Yes Yes Yes Yes Yes Yes
DF-800 Yes Yes Yes Yes Yes
No device Yes Yes Yes