Filter
Top Products
Installation
2 - 5
1. Connect at least one printer to the EPS using an available serial or parallel port.
2. If desired, connect a terminal to port 1 (the console port) to receive diagnostic and initial
configuration messages.
3. Connect the EPS to the 10/100BASE-T network.
NOTE: The default serial port settings are 9600 baud, 8 bit characters, and no parity.
4. Attach one end of the power cable to the EPS; plug the other end into an electrical outlet.
Power will come on automatically.
5. Allow 45 seconds for the unit to fully boot. The OK LED should be lit to show the unit is
functioning properly.
If you have connected a 10BASE-T cable to the Server, the Link LED should be solid
green. If you have connected a 100BASE-T cable, The Link and 100MBit LEDs should
both be solid green. If not, check your network connection.
6. Print a Test page by pressing the Test/Reset button.
NOTE: If the Power LED does not light or the Test page does not print, refer to
Appendix I, Troubleshooting.
7. Install EZWebCon on your 32-bit Windows PC to configure your Server. The EZWebCon
software is located on the CD-ROM. See EZWebCon Configuration on page 3-2 for more
information.