Lantronix EPS4-100 Network Card User Manual


 
TCP/IP Configuration
4 - 20
4.4.3 LPR on SCO UNIX Hosts
LPR is supported in SCO V3.2 release 4 with TCP/IP Version 1.2 and greater.
To configure a print queue using LPR:
1. Issue the mkdev rlp command. This will install the Berkeley remote printing files and exe-
cutable programs.
NOTE: The mkdev rlp command should only be issued once, or serious problems
will occur. If this happens, contact SCO technical support.
You can print to this queue using normal lp syntax once the remote printer is set up.
To create a remote printer:
1. Issue the rlpconf command.
2. Answer the questions that follow. See the figure on the next page for more
information.