Filter
Top Products
3: Command Line Interface
PremierWave EN Command Reference 13
Note: >To configure the PremierWave EN, you must be in the enable level and any of its
sub-levels. Figure 3-4 below shows the enable level commands.
Figure 3-4 Enable Level Commands
>enable
(enable)#?
auto show interfaces auto show processes
clrscrn configure
connect connect line <line>
cpm device
disable dns
email <number> exit
filesystem kill ssh <session>
kill telnet <session> line <line>
ping <host> ping <host> <count>
ping <host> <count> <timeout> reload
reload factory defaults show
show history show interfaces
show ip sockets show lines
show processes show sessions
ssh ssh <optClientUsername> <host>
ssh <optClientUsername> <host> <port> ssl
telnet <host> telnet <host> <port>
trace route <host> tunnel <line>
write xml
<enable>#
See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels,
commands, and descriptions.