Filter
Top Products
1 Power supply support bracket
2 Power supply release tab
13. Close the bezel.
14. Install the side cover (see “Installing the side cover” on page 134).
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
If you have other options to install or remove, do so now; otherwise go to
“Completing the installation” on page 130.
Removing an optional tape drive
To remove an optional full-high tape drive, do the following:
1. Read the safety information (see “Safety” on page vii and “Installation
guidelines” on page 37).
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Unlock and the side cover (see “Removing the side cover” on page 43).
4. Open the bezel. Place your finger on the pull-point area on the left side of the
bezel door and rotate it away from the server.
5. Rotate the power-supply cage assembly out of the chassis. Lift up the
power-supply cage handle and pull the power-supply cage assembly all the
way up until the retainer latch locks the cage in place on the chassis.
1 Power supply
2 Power-supply handle
6. Remove the air baffle (see “Removing the air baffle” on page 44).
7. Remove the fan cage assembly. Press in on the fan cage assembly release
buttons on the sides of the chassis to release the fan cage assembly from the
connector on the chassis. Lift the fan cage assembly up and out of the chassis
66 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide