Filter
Top Products
Replacing the optical drive
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the ThinkCentre Edge Safety and Warranty Guide that came with your computer. To obtain a
copy of the ThinkCentre Edge Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the optical drive.
Note: The optical drive is available only in some models.
To replace the optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other at surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 91.
4. Locate the optical drive. See “FRU locations” on page 82.
5. Remove the screw 1 that secures the optical drive, and then slide the optical drive to disconnect the
optical drive from the optical drive cable. Remove the optical drive out of the optical drive bay.
Figure 18. Removing the optical drive
6. To install a new optical drive, slide the new optical drive into the optical drive bay to connect the cable to
the optical drive.
94 ThinkCentre Edge Hardware Maintenance Manual