Filter
Top Products
Diagnostic Error Code FRU/Action
018-250-XXX PCI Card Services error 1. PCI card
2. Riser card, if installed.
3. System board
020-000-XXX PCI Interface Test Passed
No action
020-0XX-XXX PCI Interface error 1. PCI card
2. Riser card, if installed.
3. System board
020-195-XXX PCI Test aborted by user
Information only Restart the test, if necessary
020-196-XXX PCI test halt, error threshold exceeded
1. Press F3 to review the log le.
2. Restart the test to reset the log le.
020-197-XXX PCI test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 53.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
020-198-XXX PCI test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 53
.
2. Flash the system and re-test. See “Flash update
procedures” on page 151.
3. Go to “Undetermined problems” on page 78.
020-199-XXX PCI test failed, cause unknown 1. Go to “Undetermined problems” on page 78.
2. Flash the system and re-test. See “Flash update
procedures” on page 151.
3. Replace component under function test.
020-262-XXXPCI system error 1. PCI card
2. Riser card, if installed.
3. System board
025-000-XXXIDE interface Test Passed
No action
025-00X-XXX 025-01X-XXX IDE interface failure
1. IDE signal cable
2. Check power supply voltages.
3. Reseat IDE signal cable.
4. IDE device
5. System board
025-027-XXX IDE interface Conguration/Setup error
1. IDE signal cable
2. Flash the system. See “Flash update procedures”
on page 151.
3. Reseat IDE signal cable.
4. IDE device
5. System board
Chapter 7. Symptom-to-FRU Index 67